Selling my 1972 ORIGINAL short-bed step-side C-10 Pickup Truck. Itcame stock with an Inline 6 250 Cu inchengine
Started a motor swap to a SBC V-8 327 with 350 heads.
New Headers
New Intake Manifold
Rebuilt Carb
Saginaw 3 speed manual transmission with brand new clutch and throw-out bearing (shifter on the floor)
All seals are brand new on engine
Engine has new Cam and lifters
New engine mounts and rubber.
Brand new Painless wiring harness
New HEI Distributor and plug wires
New Spark Plugs
New Alternator
New Water pump
AZ truck its whole life as far as I know, Little to Zero rust (some on cab floor when I purchased in 2003)
Flowmaster 40's ready to be installed on headers
2 inch drop springs installed in the front and 3 inch drop blocks installed in the back.
Engine was running when I purchased for the install, I don't have the clutch linkage (Z-Bar) for the transmission so it has not run since I installed it.
Needs new tires and New rear Drums and belts.
The front bumper was not installed when I purchased the truck and I don't have one for it.
This is a GREAT project truck.
Unaware of total Mileage.
Buyer is responsible for Shipping or Pickup.