1955 Chevy 3100 Pro street Big block 496 first series

19550000 Chevrolet Other Pickups Description

I bought this truck all original for my business but the straight 6 started knocking so 4 months later this is how it ended. I am only selling due to that I am moving overseas and there is no point it sitting for years. I have every receipt and list of every part that is in this truck which totals over $40,000. I will accept deposit on Paypal but balance will be paid by wire or cash. Also have brand new car trailer that I am willing to let go with it for additional$1,800. It is brand new 2017. I can help arrange shipping or whatever help you may need. This is my first classic
Frame is original except where the bed is bolted on where has a custom rear set up. I have pictures of the truck from the day I bought it to the progress of everything that was being done. Hopefully you can see the amount of detail that was put in it. There is some things left to do like, install windshield wipers and very simple stuff. I do have the window rubbers and door rubbers brand new that need put on. If you would like to see the photos of the build please let me know and I can email them. Truck has under 500 miles on it. Truck floors are original with NO rust and have the pictures to prove before the build. I do have parts for the truck that will go with it that are not installed like front bumper and brackets, door panels, and window rubbers.
Just in the transmission and rear end is over $8,000 worth of parts without labor
BodyWas repainted in the 70's and all original when I bought it.New windshield and rear window with new rubbersAmerican wire wiring harness.Dakota Digital gaugesNew carpetSeats are in excellent condition with no wear or tears. It was like that when purchased.Recessed firewallWire tuck "where wires are not seen anywhere under the hood"new head lightsnew tail lights and bracketsnew brake light switch



TiresVintiques 15x6 front with center caps and beauty ringVintiques 15x15 rear with center caps and beauty ringMickey Thompson Sportsman 29x18-15Mickey Thompson sportsman front
Rear EndCurry Ford 9 inch rear end cut downLimited slipGm hubsBreather393 GEARS
SuspensionMustang 2 front end4 link suspensionAdjustable shocks4 Wheel disk brakesnew under floor master cylinder2psi check valves for brakes
TransmissionBowtie Stage 3 700r4 WITH OVERDRIVE2400 stall torque converterLOKAR SHIFTER
Engine

THIS BLOCK HAS BEEN OVEN CLEANED(HAS NO RUST OR SCALE), SHOT PEENED, MAGNAFLUXED AND PRESSURE TESTED.

THE BLOCK IS FRESHLY BORED AND TORQUE PLATE MOLY HONED TO .060 ALL BLOCKS ARE ALSO SONIC CHECKED TO ENSURE CONCENTRIC CYLINDER WALL THICKNESS AFTER BORING AND HONING.

THE BLOCK HAS BEEN LINE HONED, SQUARE DECKED, AND NEW CAM BEARINGS INSTALLED ALONG WITH NEW FREEZE PLUGS. ALL BOLT HOLES AND THREADS ARE FINE.

THIS ENGINE HAS A BRAND NEW SET OF LIGHTWEIGHT, FULLY CNC MACHINED WISECO FORGED RACING PISTONS AND SPEED PRO PLASMA MOLY RINGS ( 5/64, 5/64, 3/16 OIL) THESE PISTONS YEILD A PUMP GAS FRIENDLY 10.25:1 COMPRESSION RATIO. PROBE IS AN INDUSTRY LEADER IN RACING FORGED PISTONS.

NEWKING H BEARINGS FOR RODS AND MAINS, ROD AND CAMSHAFT BEARINGS WERE INSTALLED. THE CAMSHAFT IS A NEW COMP CAMS 11-324-4 AND WITH A TRUE CLOYES DOUBLE ROLLER CHAIN SET. THIS CAMSHAFT IS A HYDRAULIC LIFTER GRIND .568 LIFT INTAKE AND 578 EXHAUST 244 INTAKE AND 246 EXHAUST DURATION @.050 AND IT IS GROUND ON 110 DEGREE LOBE SEPERATION. THIS CAMSHAFT HAS A DISTINCT LOPY IDLE AND IS DESIGNED TO MAKE MAXIMUM POWER IN THE2500-7000RPM RANGE. INSTALLED ALONG WITH THE CAMSHAFT IS A NEW SET OF ELGIN HYDRAULIC LIFTERS.

RODS ARE BRAND NEW PRO-COMP ENTERPRISES FORGED STEEL H BEAM CAP SCREW WITH 7/16 BOLTS AND FULL FLOATING WRIST PINS. THE RODS ARE 6.385 (STOCK ROD LENGTH IS 6.135) THESE RODS ARE .250 LONGER THAN STOCK. THE INCREASE IN ROD LENGTH PRODUCES LESS SIDE LOAD ON THE PISTON WHICH RESULTS IN LESS FRICTION AND GREATER HORSEPOWER AND TORQUE THROUGHOUT THE RPM RANGE.

THE CRANKSHAFT IS BRAND NEW AIRCRAFT QUALITY PRO-COMP CAST STEEL 4.2501 PIECE REAL SEAL CRANKSHAFT.THE CRANKSHAFT IS SHOT PEENED FOR STRESS RELIEVING AND HAS A FULL .125 RADIUS ON THE MAINS AND ROD JOURNALS!, THIS CRANKSHAFT IS ALSO INTERNALLY BALANCED AND IS THE BEST OF THE BEST!!(4.250 STROKE, 1/4 INCH LONGER THEN STOCK 454), FRESHLY MICRO POLISHED AND STANDARD ON THE ROD AND MAIN JOURNALS.

THIS ENGINE IS FULLY BALANCED ON OUR NEW RMC COMPUTER BALANCER AND IT IS ALSO BLUEPRINTED. PISTONS, RODS AND CRANKSHAFT ARE BALANCED TO LESS THEN 1 GRAM. ( MOST MACHINE SHOPS ONLY BALANCE TO A 5 GRAM SPREAD) BEARING CLEARANCES WERE SET AT .002 ON BOTH THE MAINS AND RODS.

THE CYLINDER HEADS ARE NEW PRO-COMP ALUMINUM RECTANGLE PORT WITH D PORT EXAUST PORTS(STOCK HEADERS AND EXHAUST MANIFOLDS WORK FINE PORTS ARE IN STOCK LOCATIONS PLUS ALL STOCK BRACKETS LINE UP). HEADS HAVE BEEN ASSEMBLED WITH NEW STAINLESS STEEL SWIRL POLISHED MANLEY VALVES (2.25 X 1.88). THESE VALVES ARE 11/32 STEM AND .250 LONGER THEN STOCK, A NEW SET OF DOUBLE SPRINGS AND CROMOLY RETAINERS WITH HARDENED LOCKS AND A NEW SET OF PC SEALS. THESE HEADS ALSO HAVE NEW STAINLESS STEEL 1.7 RATIO FULL ROLLER ROCKER ARMS, NEW PUSHRODS, NEW ROCKER STUD, NEW GUIDEPLATES AND A NEW SET OF 12 POINT ARP HEAD BOLTS WITH TEFLON TAPE FOR BEST SEAL!!!.

HOLLEY 950 ULTRA XP CARB

HIGH RISE INTAKE

BILLET SPECIALITES ALTERNATOR BRACKET

4 ROW ALUMINUM RACING RADIATOR AND ELECTRIC FAN

3 INCH ELECTRIC CUT OUTS

SERIES 40 MUFFLERS

HIGH TORQUE STARTER

MAX FLOW 14X5 AIR FILTER

HIGH VOLUME WATER PUMP

7' INTERNAL BALANCED BALANCER

MELLING HIGH VOLUME OIL PUMP. OVER 70PSI WARMED UP

6 QT OIL PAN

TALL ALUMINUM VALVE COVERS

NEW BATTERY

Spark plug wire heat shields

Taylor spark plug wires

MSD Hei distributor

Holley high volume mechanical fuel pump

Stainless steel gas lines with filter from gas tank to fuel pump

Stainless steel line from fuel pump to carb

Stainless steel intake lines to equal water temperature

Wilson racing intake spacer

Chrome alternator

Billet specialtiesOil dipstick

The only thing else I was going to do is repaint the roof white and age it and put my company logo on the side. As you can tell the patina is not like most trucks you see. I was told the paint on the truck is enamel which has an extremely old paint job on it.
424-333-1702 is my cell phone number and will be uploading videos of it running and will be updating listing. CLEAR TITLE IN MY NAME THAT IS IN MY POSSESSION

On Nov-05-17 at 18:39:32 PST, seller added the following information:

Video of the truck running. Also shows the sound difference with the electric cut outs open and closed with a flip of a switch.https://youtu.be/-sXus_KlAig