The first-generation Chevrolet Camaro appeared in Chevrolet dealerships in September 1966 for the 1967 model year on a brand-new rear-wheel drive GM F-body platform and was available as a 2-door 2+2 seat hardtop (no "B" or center pillar) or convertible with a choice of six-cylinder and V8 power plants. The first-generation Camaro was built through the 1969 model year. Almost all of 1967-1969 Camaros were built in the two U.S. assembly plants: Norwood Ohio and Van Nuys California. There were als...o five non-U.S. Camaro assembly plants in countries that required local assembly and content. These plants were located in the Philippines Belgium Switzerland Venezuela and Peru. GR Auto Gallery is pleased to present this 1967 Chevrolet Camaro for consideration. This Camaro is powered by high performance 427 cubic inch V8 motor and paired with a Richmond 5 speed manual transmission. This is a fresh restoration that was completed in 2011 with minimal road miles on the car since. All of the vinyl appears to be newer the tires have tons of tread left on them the vehicle also has an aftermarket tachometer oil pressure and temperature gauge. This Camaro is a stunner showing excellent condition inside and out. With a simple turn of the key the 427 comes to life and idles and drives great. Please call or email us today for more information on this 1967 Chevrolet Camaro. To see over 80 photos of this car including under carriage please visit our website