Custom 66 C10 LS motor, accuair, AC, Porterbuilt suspension full Reso-mod

1966 Chevrolet C-10 Description

This classic truck has undergone a complete frame off Restomod. The heart was replaced with a LS motor and 4l60e transmission. The suspension was completely replaced with a full Porterbuilt kit to lay frame, new upper and lower control arms, dropmember, an adjustable wishbone rear end, all of this is controlled via Accuiar with a tank, two vair compressor.

Completely rebuilt rear differential with posi was installed. All new lines/wiring on the truck including steel braided fuel lines with anodized fittings, and all new hard lines for the brakes. Relocated the gas tank and replaced with a Custom Boyd fuel cell (installed between the rails below the bed), with custom flush motorcycle gas cap installed in the back fender of the bed for that extra touch. All new trim package installed and wrapped in black vinyl. Tons of Custom sheetmetal work was done, truck has been cut to be in the middle of a long-bed and short bed, a custom hinge opens up to show theaccuair and compressors, the tubs are all custom and dimple died.Customfrontgrill was made with LED lightsbehind the mesh, all bumpers were cut and fit one inch off the body. thebed sides were sprayed with line-x. and customled's and pop out tie downswhere installed so the truck bed could be fullyfunctional.

Moving inside the truck was gutted, whole 5 gallon lizard skin sound proofing/ sealant was laid down, followed by dynamite along the firewall and transmission covering. All wiring redone and new wiring harness installed, Dakota digital gauges, vintage air kit installed for AC/heater, all interior steel painted black, set of two Chevy Tahoe seats, new window motors installed Keyless for push to start!! custom push buttons for all leds, lights that are hidden behind the front grill and installed flush into the custom bed. New glass was installed along with all new weather stripping.

The interior has not been finished leaving the buyer a clean slate for seat covers, audio, and interior finishing.

A mild Cam was installed, headers, Full custom exhaust, intake manifold and holly EFI. All parts have been powedercoated black and sit in a completely custom engine bay with one off fenders, dimple died and fabricated by nostalgia hot rods in Las Vegas.

This truck is a great dailydriver or weekend car. i built it to look like a show car but be dependable and usable like a real truck.

Too much to list, serious inquiries ONLY.

NO TRADES!!