1972 Chevy K5 Blazer CST
I will not sugar coat the details of this Blazer. I will tell you the good and the bad. I have looked at a lot ofunrestored 69-72 Blazers over the years and most of them were just too far gone.I believe this one is a fairly solid starting point. However...IT NEEDS A LOT OF WORK. This Blazer has never been anywhere near Arizona. It is by no means rust free.
This Blazer is pretty much unrestored with the exception of the mechanical things listed below. It has not been crunched, crashed or chopped. The good thing is you can see what you have to start with. Although it has some of the Blazeristic rust issues, most of it is below the side trim line. The outer rockers have been replaced a while back. The rocker boxes have been removed and you can see all that is usually hidden behind them. It run, drives and stops but I only drive it around town. It will need to be trailerd. Please feel free to ask me anything about it.(before bidding)
Vehicle being sold as is . It is also for sale locally, so I reserve the right to end the auction at any time. I try to describe it as honestly as possible, but cannot guarantee anything.
-All original body panels except tailgate
-Frame is straight and has just lightrust
-Wheel openings are nice
-Grill and surround is in good shape
-Bed sides are straight
-Original bucket seats and correct style Blazer rear bench seat
-Original center console
-Uncut dash
-Upper window frame and cowl is solid
-350/TH350 runs pretty good but could probably use a little tuning. (not original motor)
-New exhaust
-New fuel tank/sender
-New aluminum radiator
-New master cylinder/booster
-Decent single wall top
PANEL DETAILS
-Left front fender solid and straight
-Right front fender has a quarter sized hole on the front underside and a small hole near the door but otherwise straight.
- Hood has a dent in the ornament area. (extra hood included)
- Doors will need some work on the lower skins and bottoms (2 extra donor doors included)
-Bed sides are straight with rust on lower front corners by doors
-Tops of bedsides have some rust holes where top sits (only in 1st layer)
-Bed floor has a rust hole in front of left wheel well and a crappy repair job done on the very back edge of floor. Otherwise solid. (not as bad as it looks, has yellow carpet glue on it)
-Tailgate is not original and could use some work (donor tailgate included)
-Needs new rubber body mounts
-Left taillight area has a dent
-Rocker boxes have been removed
-Floorboards are fairly solid except for outer front corners