1947 ford Truck 454 Crossram front drive Magneto 400 trans w/ 9"

1947 Ford Other Pickups Description

I am willing to just sell the truck als, I will pull Motor and trans if you like. and sell for $6000
Hello i have a project truck For sale ( will get more pictures posted later of parts etc.)
Before you send email I do have the front grill piece its straight and hanging in the garage.
I have had this Truck for some time, it is Registered and Insured .Registered withoriginal period Correct Plates for the car 6# plates yellow with black letters.
(Truck Has a Rebuilt BBC 454 Ovalport motor in it all ready mounted, Rebuilt shortturbo 400 Trans mounted, I have correct length 9" for it with correct bolt pattern ( not installed) with Coil Overs ( truck hadSBC in when I bought it, old school conversion done back in the 6o's) to drive car now needs headers finished on driver side, pass. side has full length done. ( did not want to use stock exhaust) driver side has clearance issue with steering box. Also Have 2.5" exhaust with flow masters for it.And a new drive shaft needs to be made ( because we switched out the old long turbo 400 for a rebuilt short stronger Turbo 400 trans.) also if you do not what to run the 9" the banjo rearend in the truck already has the "Ford 6 spline open drive conversion kit" in stalled.
Stock firewall in tack, motors fits with big HEI in place no problem, used old hurst engine mount and bolts right to stock location where flat head V8 mounted.
Fuel system, tank boiled out, new sending unit, new electric perf. pump new lines etc.
Motor Parts i have to go on truck 2nd stage of build: Ported Square port ( factory Performance heads), Crossram with carbs, Front drive Magneto setup, Custom made sheetmetal valve covers, Monster Aluminum 4-row Radiator, etc.
Wheels are Crager Chrome Smoothies, with 3" whitewall, New tires, fat socal piecrust recaps on radials, and front skinnies but not two small.
Have rebuild kits for all the brakes, i have aftermarket power brake booster that fits in stock location under driver floor board etc.
Body all ford steel, i have brand new tailgate made from factory dies, Have a brand new wood bed kit for it with stainless straps, I have extra body parts( two Hoods and Fender) also have old tail gateparts that came with truck when i bought it, i also have extra brand new rear factory springs that came with the truck, lots of parts to sell off or keep when you make it your own.
Would not take much to get this thing road ready, great project for a shop that wants to flip it and make good money etc. Remember i was building a ratrod
buyer is responsible for all shipping costs
Thanks for looking. any questions call 1-818-371-3273