Home / Ford /

1966 mustang Coupe Project

Price: Ask a price!
Location: Lone Jack, Missouri, United States
Condition: Used
Make: Ford
Model: Mustang
Type: Coupe
Year: 1966
VIN: 6R07C129159
Engine size: 302
Transmission: Auto C4
Vehicle Title: Clear

1966 Ford Mustang Description

1966 Mustang Coupe Project
Body:
I have had a good bit of body work competed with only a couple of areas that need attention. Around the gas tank in the trunck has some rust and needs repaired. Also the rear floor pans need to be replaced. I have the left floor pan. The right floor pan was replaced but they did a poor job it needs to be re-worked. The roof had some rust from the original vinyl top but it has been repaired. I have over $13k invested over the years but it is time for someone to breath new life into this classic.	New Left front fender
New right front fender
New left quarter panel
New right quarter panel
Drivers door great shape
Passenger door good shape (have new skin if needed)
Tail light panel okay shape (have new panel)
New Front fiberglass valance 2 styles
New rear valance
New front bumper
New rear bumper
New Fiberglass Shelby hood
New Fiberglass Shelby style trunk lid
Roof good shape
Trunk area needs some repair (have a new fuel tank in the box)
Rear floor pans need some work (have the left pan)
Front floor pans are in great shape
Glass
Windshield Glass
Drivers: door, vent and rear
Passenger: door, vent and rear
No rear glass
Engine & Compartment:
Engine is a 302 that I had rebuilt in 1992 and has about 5k miles on it. (It came with the car when I purchased it) Transmission is a C4 and was rebuilt at the same time as the engine. The engine needs new lifters and both engine & Trans would need new seals but should be good to go other than that. I have alot of chrome engine parts as well as a set of 351 E7TE heads that I was going to install. I had also planned to install a roller cam and lifters. There are $3300 in engine parts and fiberglass that are mostly still in the box and never installed. The fiberglass body parts have been installed but not used on the road so still in great condition.	Engine Block 302 w heads
C4 Transmission
Stock 302 Heads
351 E7TE heads
Chrome Oil Pan new in box
Chrome Starter new in box
Aluminium Pulley Set new in box
Chrome Water pump new in box
Aluminium Valve covers & Oval Air Cleaner new in box
Chrome 140amp alternator new in box
engine wiring harness
Edelbrock Performer aluminium intake
Mallory dual point ignition needs cleaned up
Holly 4bbl carb needs rebuilt
351 engine with marine GT40 heads included (needs rebuilt)
Suspension Steering & Brakes
Brakes need new cylinders and master cylinders
Suspension is tired and would need rebuilt
I would replace all the ball joints to be safe
Power Steering Components
Electrical, Guages & interior
Original wiring harness
Original Guages
Original interior