Pro Street 67 Mustang Fab 9 rear 4-link coil overs Heidts front Shelby GT drag

1967 Ford Mustang Description

This is a 1967 Mustang coupe Pro Street or race project car. It is being sold as a rolling chassis. It has full tube chassis and all the sheet metal tubs and floor work is nicely done. In the rear it has a NEW Chassis Works Fab 9 housing and 4-link with NEW Aluminum VariShock coil over shocks. The front has a Heidts front suspension with NEW drilled and slotted 5 lug Mustang 2 rotors and calipers and tubular upper and lower control arms. No rear brakes or carrier. It has 15x3.5 Centerline front wheels and the rears are just 15x10 but it comes with NEW 15x14 Weld Dragstar wheels. It has a 12 gallon fuel cell. NEW front and rear chrome bumpers and new brackets. 2 new quarter panels (not installed), fiberglass front fenders and trunk lid with aluminum wing. All glass is good. It also comes with some trim pieces and front and rear valance panels. It has a stock hood but no grill. It has small block Ford front and mid plates. It has NEW guages in a NEW stock dash panel but it will need a dash pad. It comes with a painless switch panel. The roll cage had funny car bars that previous owner removed for some reason. I plan to put steel front fenders on if I finish it. 4358496085. This is a project car but the hard work has all been done. I do not have a title but I have the last registration. Buyer responsible for procuring new title.

On Jul-13-17 at 07:42:50 PDT, seller added the following information:

I also have an all aluminum Boss 438 ci Clevor engine in another listing that was built for turbos or a supercharger up to 2000hp.