FOR SALE
1930 Model A rat rod
This 1930 Model A rat rod is far from what most consider a rat rod to be. From the sprint car steering box, to the charcoal and black carpeted interior. Down to the custom boxed and smoothed frame. This car is very well built and looks bad ass. The fully adjustable air suspension allows this rat to lay on the ground when parked, or raised up to get over those annoying speed bumps. Pics don’t do it justice, there is hundreds of hours in building this one.
DRIVETRAIN
2000 Chevy Silverado 4.8L engine
Edlebrock intake manifold
Edlebrock 1412 carb
Edlebrock ignition system
Comp Cams Ls1 Cam XR269HR-14
Holley fuel pump and regulator
Aluminum PSR fuel cell
700r4 Transmission
B&M 80776 shift kit
Chevy 10 bolt rear end (I’m not 100% sure on that)
Pete & Jakes 5 link in rear (installed by Phil Borriello’s Chop Shop)
Speedway Motors wire harness
Hi and low beam headlights
Turn signal switch with hazards
Sprint car steering box (installed by Phil Borriello’s Chop Shop)
Removable steering wheel
11” disc brake kit for ‘37-‘48 Ford spindle
Speedway Motors master cylinder & pedal assembly
Custom headers & exhaust Magnaflow muffler (done by Dracut Exhaust and Brake)
Heat wrapped headers
Muffler heat blanket
Air Ride Technology air ride system with level sensors
Front Shockwave air shocks
Rear airbags with separate shocks
Dakota Digital cable drive adapter for speedo (this still has to be programmed)
BODY
Custom frame (frame goes under the body so the floor is not channeled)
Frame is boxed, smoothed, and painted
Suicide doors
Chopped roof
Custom windshield visor
Power sunroof (I believe it’s from a Ford Explorer) sunroof vents and retracts into the roof liner
Frenched Cadillac led taillights
Body was finish bodyworked and painted gloss black prior to the rusting paint process. I purchased the car a couple years ago, made some changes and finishing touches.
Basically everything on this car is new. Only been driven a couple miles for test and tuning of suspension and carb setup.