1972 Mazda RX-2 BP 12A Track Project
1972 Mazda Other Description
Car is registered in Texas, I have a clear blue title in my name. Only listed as a track project because that's what it is.
THE CAR CAN BE DRIVEN ON THE STREET AND IS STREET LEGAL.
The Important Details:
-Fresh 0-Mile Bridgeport 12A Motor-4speed transmission installed. (5-speed from an 82 RX-7 Included as well)-Mikuni PH44 Sidedraft carb W/ K&N Filter box, and Velocity Stacks-Old School Single Piece Wrap Around Intake Manifold-Racing Beat Road-Race Header-Aluminum 3-core Radiator-Holley Fuel pump, FPR, -AN Fuel Lines-13 Gallon Fuel Cell-6 Point Roll Cage-Full Chassis Painless Wiring Harness-15x7 Centerline Dragline Wheels-Moroso Switch Panel-LSD Rear end from a Hilux.
Car runs well, I just recently borrowed the cap, wires, coils for my FB RX-7 for testing, but will have them re-installed and take a video, and post compression numbers as well. Later this weekend.
Everything not seen in pictures is included in the car in boxes, Trim, bezels, Glass, Ect. Unless Specified as missing below.
What's Missing?:
-Vinyl Top Trim-Front/Rear Bumpers-Emblems-Steering Wheel-Gauges-Cooling Fan
Backstory:
-Bough the car back in 2010, Previous owner had it setup for Road-Race. They did all the cage, body work you see, built the motor. Iv'e handled most of the drive-ability, and service issues, Wiring, brakes, cooling system, fuel system.
-The car car intended to be a track car, the body work is NOT GOOD, THERE IS ALOT OF BODY FILLER.
Finer Details:
-Good news is the car came from California, so there isn't any deep, structural or major rust. Just small surface stuff. Minus the front A-Pillar where the vinyl top was trapping water, and on on the roof. The pillar has been patched, but needs finishing.-There are dents, dings, the metal on these cars is TERRIBLY THIN, and being in storage it's had a few bumps.-Tires that are on it are OLD and DRY ROTTED. They will hold air to push or move around, but cannot be driven on.-Drivers rear window is included, but not shown.-The seats were brand new upholstered seats from a Datsun...510 I think.
In Conclusion:
-Iv'e been in RX's for a little over 10 years, Iv'e owned nearly a dozen, built a few motors, and raced them as well. I know the market pretty well, and have seen what they go for, I am not delusional however, I know the car needs work, that's why im letting it go. I don't have time to mess with this one and my other Turbo FB build at the same time.
-However they are getting rarer and rarer, and if it doesn't sell fine. It will go back into storage and get it's time in the sun to be brought back to it's former glory.
-The car is listed locally on Craigslist and a few Facebook groups as well, and if it sells I will pull down this ad.
Buyer is responsible for shipping. There is no Warranty, Car is being sold AS-IS, WHERE-IS.Thank you.
More Mazda classic cars for sale