65 Shelby cobra kit by Glaspac Cobras/unfinished

1965 Replica/Kit Makes Cobra Roadster Description

This was a project car I just can not find the time to finish and needs someone with the extra time to have a really nice car when completed. It is titled as a 1984 and was originally produced by a company called Glaspac Cobras. There is way to much information to discuss with text, please feel free to call me so I can bring you up to speed on what has been done and what still needs to be done as well as an extensive parts list. Some new parts still in boxes. You can call me at 804-436-3388, Clay.

On Jan-27-19 at 18:21:08 PST, seller added the following information:

- Rear axle is posi out of a 1998 Ford Mustang Cobra- Transmission is a Top Load 5 speed- New full set of Auto Meter gauges still in box- New "Painless Wiring" Starter harness, still in box- Halibrand knock of wheels, needs aluminum polishing- 289 Bare engine block, Sitting in car for mock up purpose only- Front suspension new tubular mustang II, needs some welding and some modifications to frame.- New Flaming River steering rack- New Flaming River front and rear coil overs- 2 windshields- Headers, body needs finishing modifications for these headers where they exit for the side pipes- Side pipes, need some work, have a lot of surface rust, never used.- Will need a new fuel cell for the trunk area, the original tank goes with the car but with the addition of the dual roll bars original tank will not work.- Edelbrock performer RPM heads, intake and cam, however these parts will not work on the 289 block, parts were purchased for the original 351, decided to go a different direction with the 289 so I sold the original 351 engine out of the car. You will either need to sell these heads and get the correct heads or find a 351. Even though these heads are new they are about 8 years old, I would have them checked and resealed.- Body is fiberglass, needs to be sanded down or blasted and repainted.- Drivers pedal area was very narrow in this car and pedals were terrible. Cut the trans tunnel and spaced it over about an inch to gain more foot room, only tack welded in, needs to be finish welded.- Installed a Wilwood pedal assembly- Will be adding more pics on 1/28 to show what parts come with the car.

On Jan-28-19 at 04:59:50 PST, seller added the following information:

On Jan-29-19 at 12:19:27 PST, seller added the following information:

I also have a hard top for this car, however the only way to use it is to not use the roll bars, this is not something that you swap back and forth you will need to make the decision if you want the roll bars or the option of the hard top. I have a pic of the top but Ebay won't let me add any more pics for some reason.

On Jan-31-19 at 03:40:15 PST, seller added the following information:

I have had several calls about the doors, YES, the car comes with both doors.