Ferrari 308 GTS Replica

1986 Replica/Kit Makes Ferrari 308 GTS Description

This car is an absolute head turner and an awesome car to bring to shows. I finished working on it this winter, here is what I replaced.

• Brake pads / Rotors / Calipers
• ECU
• Spark Plugs
• 8.5 mm distributor wires
• Oil / Filter Change
• New Coolant
• Gas tank dropped and cleaned
• Catalytic converter removed and straight piped

Car is built on a 1986 Pontiac Fiero SE. I have the receipt from the shop somewhere and should be able to provide if i find it. Car has been kept in a garage since 2000 when it came to Illinois, Only 27,541 original miles on the car which is low just for a fiero alone. It is a 4spd manual which is fun to drive. You have to push the clutch down pretty far and its not super grippy so I would recommend bleeding the clutch. The yellow read drivers side taillight cover is broken along with the front blinker cover but the bulbs are still intact I believe. Steam come out of dash vent occasionally so you are going to need to replace the heater core which is a lot easier on a fiero actually. Also when I was removing the calipers I had to cut the e-brake like to the rear drivers side in order to remove it so you will have to replace that piece of the line and tighten it. Luckily its sold in 3 pieces so you only need 1 pieces more than likely rather than all 3. Not sure if radio works. Does occasionally leak small amounts of coolant from the pipes running under the car. There are chips in the paint here and there, mostly on drivers side door on the edge, around exhaust and near trunk. That is everything that I know about the car but I encourage questions and you are more than welcome to come check out the car. It is located in Burbank IL. By purchasing this car you agree to the current condition its in because it is sold as-is and I will not be accepting any returns. I am not a mechanic but I can answer your questions to the best of my knowledge. Buyer is responsible for shipping.