Jeep Willys Pickup, 1951
I purchased this truck last summer with the intention of restoring it, but i have too many projects, and need to find it a new home
The Willys is located about 10 miles from the Texas Motor Speedway
I have been on EBay for over 10 years with 100% Positive Feed Back---- Please E-Mail Questions
Clear Utah Title in the previous owner's name
Inspections by you or your representative are encouraged
Sold without warranty
I reserve the right to end this listing as it is advertised in other places
The following is the description of the work done to the truck by the previous owner---- it is a solid Truck and I hate to let it go:
This classic Jeep Willys Pickup has been mechanically restored and is ready to drop in a v8 of your choosing. All of the dirty greasy work has been completed to factory standards and is ready to go. I have $6,500 worth of parts (with receipts) into restoring this truck.
This truck has resided in the Utah desert for decades and escaped the rust issues plaguing most of these beautiful trucks.
AmazingRust-Free desert body and chassis. Including original floorboards, straight pickup bed, straight tailgate. Only minor rust in one of the stake pockets. Body mounts have all been replaced and everything sits straight, hood opens and latches smoothly.
Front axlefully overhauled-- including new knuckles, kingpin bearings, and all rubber seals.
Rear axleresealed. Both axles full of oil and ready to roll.
Brakes- New master cylinder, all rubber flex lines, 4 wheel cylinders, and 2 new brake drums. Ready to all fluid and bleed.
Front Leaf springs, shackles, bump stops and bushings all replaced with new.
Rear suspension gone through with new grease zerks used as needed.
RossSteering gearoverhauled with new pitman arm and bearings.
Steering linkagenew tie rods, and all new bushings
T90transmissionoverhauled with new Novak adapter and bell housing to bolt up any small block Chevy
Dana 18transfer caseresealed
Warn Overdriveresealed. This overdrive adds a 4th shifter stick in the interior and allows you to overdrive any gear 25%, low range or high range. Equivalent to a 6 speed transmission
Newclutch linkageinstalled connecting stock clutch pedal to gm release arm
New USA maderadiatorbolted to a shortened grill shroud, freeing up space for installing a v8 or i6
Rareoriginal bench seatallows access to under seat storage. Needs minor spring work and new upholstery.
Fuel tankis leak free and gauge sender tested
Included but not shown in picture of truck
Front bumper with brackets
Front and Rear Drive shaft
Extra lights
Heater
Misc wiring pieces. Truck needs engine/ wiring/ fuel lines before it is roadworthy.