1967 Chevrolet Chevelle Malibu 2 Door Hardtop + New Parts

This is a list of the items currently on the car.

New Doors ($685)-Receipt

New Fenders ($600)

New Hood ($399)

New driver side Quarter Panel ($400)- Receipt

New Trunk Floor Pans ($190)-Receipt

Doors, Fenders and Hood need alignment.

Doors are currently held with bungees for the time being until aligned.

New BF GoodRich G-Force Comp 2 All Season Tires ($1,350)-Receipt

On Charcoal Gray Retro Aluminum Wheels

17x7 (Front) 225/45ZR 17 (Tires)

17x9 (Rear) 275/40ZR 17 (Tires)

Wheel Alignment was done.

New Disk Brake Conversion All Around ($890)-Receipt

New Fuel Tank Kit ($235)-Receipt

(Tank, Cap, Meter, Straps, Bolts, Insulation)

New Eibach Pro-Kit Lowering Springs ($220)-Receipt

(2 ½ inches in the front, 2 inches in the rear)

New 2 ½ inch FlowMaster Dual Exhaust Kit ($360)-Receipt

New MagnaFlow Stainless Steel Exhaust Tips ($90)-Receipt

New Mini RPM Tachometer

Nice Rebuilt Saginaw 4 Speed Transmission($1,310)- Receipt

Transmission was disassembled and has new Syncros, Gaskets, Bearings, Rear Seal for Driveline, Snap. All Gears Glass Beaded and Repolished. Reconditioned Chevy BellHousing. New 153 tooth small 10.5 clutch Chevy flywheel. New small 10.5 pressure plate. New small 10.5 clutch disk. New throwout bearing. New pilot bearing. New clutch fork boot. Reconditioned shift rods and levers. Hardened steel pressure plate bolts. Nice original clutch fork.

New Flow Tech Headers ($138)- Receipt

New MSD Ignition 6420 Capacitive Discharge 6AL Ignition with Rev Limiter ($205)- Receipt

New MSD Ignition 8203 Blaster 2 Hi-Performance Coil ($52)- Receipt

New MSD Ignition 8213 Chrome Universal Coil Bracket ($10)- Receipt

New MSD Pro-Billet Distributor 8361 Chevy SB V8 ($206)- Receipt

New MSD 31353 Spark Plug Wires. Super Conductor Spiral Core 8.5mm (Black) with 90 Degree Boots. ($78)- Receipt

New 4 Row Aluminum Radiator ($260)

New EdelBrock Elite Series Aluminum Valve Covers

New EdelBrock Elite Series Aluminum Round Air Cleaner ($70)- Receipt

New Battery Tray ($22)

New Windshield Jar with Lid ($14)

New Heater Control Assembly ($160)

These are the list of parts that I have for the car

67 Chevelle 4 speed shifter handle ($75)-Receipt

67 Chevelle 4 Speed shifter T handle adapter ($30)- Receipt

Original bucket seats- ($300) Swap Meet

Bucket seats has original correct metal back and sides instead of the 68+ models that use plastic.

Rear Bench Seat

Original Cowl Vent Grill Panel

Front Metal Valance Panel ($69)

Manual Trans Center console (No Clock)

New front grille assembly (Ausley’s Chevelle store) ($295)- Receipt

(Front Grill, Grill Extensions, Grill Rivets, Head Light Bezels, and hood moldings)

New Rear Panel Kit (Ausley’s Chevelle) ($245)- Receipt

(trunk lip moldings, upper rear panel and lower rear panel moldings, taillight bezels

New Delux Weatherstrip kit (doors, trunk, window, verticals, hood, vent window, channel rubber, etc) (Ausley’s Chevelle Store) ($130)- Receipt

New Malibu Emblem Kit (Ausley’s Chevelle) ($215)- Receipt

(Grill Emblem, Fender Emblems, and quarter panel emblems)

New Rocker Panel Moldings (Ausley’s Chevelle) ($115)- Receipt

New Hood Loovers (Ausley’s Chevelle) ($95)- Receipt

New Door Handle Kit (Ausley’s Chevelle) ($55)- Receipt

New Front and Rear Bumpers ($330)

I also have the original doors that will be included in the auction.

Spare tire, 2 Car manuals, an extra water pump

The door windows and rear glass is not installed. The door windows are on the original doors (which is included in this listing) and the rear glass is wrapped in a protective sleeve with the original chrome trim (SEE PICS).

This car is perfect for a restoration shop or for someone who is handy with cars and has the time.

Roughly $10K+ in parts (Receipts) + various additional parts (extra set of doors (original), extra cowl vent panel (original), pulleys, extra set of original headlight bezels, spare headlight etc.)

SOLD AS IS!

Buyer is responsible to pick up parts and vehicle. I am willing to accommodate a little by storing certain parts in the vehicle when its time for pick up. It’s up to the buyer.

I understand that this lot has a lot of parts that the buyer may not want in the car when its time for transport. I am willing to accommodate the buyer in the pick up arrangements for the parts. I do not have a problem holding on to some if not all the parts for a short period of time until the buyer is able to arrange pick up.