1967 Chevy Chevelle Malibu
136 Vin
As much as I do not want to sell this car the reality is that I do not have the time nor the resources to see this project complete. I had this chevelle for over 10 years now. Worked on the car through out the years and life got in the way. Do not have the time to finish and lost interest. The Chevelle has a 350 motor in it, and a new/rebuilt Saginaw 4 speed transmission. I am including a 396 Motor (See Pics). Underneath the car is pretty much new. The car needs to be aligned and a couple of dents need to be patched and needs a driver side floor pan. The car runs. The car was primed and not painted. It was garage kept the whole time I owned it. Clean title. I am not a car expert but I will do my best to list all the details about the car and items.Roughly $10k in parts in the breakdown given. I will include the breakdown and indicate if I still have receipts for the parts and work done. I will be throwing in whatever other parts I find that goes with the car such as a spare headlight and an extra pulley. Thanks for looking.
This is a list of the items currently on the car.
New Doors ($685)-Receipt
New Fenders ($600)
New Hood ($399)
New driver side Quarter Panel ($400)- Receipt
New Trunk Floor Pans ($190)-Receipt
Doors, Fenders and Hood need alignment.
Doors are currently held with bungees for the time being until aligned.
New BF GoodRich G-Force Comp 2 All Season Tires ($1,350)-Receipt
On Charcoal Gray Retro Aluminum Wheels
17x7 (Front) 225/45ZR 17 (Tires)
17x9 (Rear) 275/40ZR 17 (Tires)
Wheel Alignment was done.
New Disk Brake Conversion All Around ($890)-Receipt
New Fuel Tank Kit ($235)-Receipt
(Tank, Cap, Meter, Straps, Bolts, Insulation)
New Eibach Pro-Kit Lowering Springs ($220)-Receipt
(2 ½ inches in the front, 2 inches in the rear)
New 2 ½ inch FlowMaster Dual Exhaust Kit ($360)-Receipt
New MagnaFlow Stainless Steel Exhaust Tips ($90)-Receipt
New Mini RPM Tachometer
Nice Rebuilt Saginaw 4 Speed Transmission($1,310)- Receipt
Transmission was disassembled and has new Syncros, Gaskets, Bearings, Rear Seal for Driveline, Snap. All Gears Glass Beaded and Repolished. Reconditioned Chevy BellHousing. New 153 tooth small 10.5 clutch Chevy flywheel. New small 10.5 pressure plate. New small 10.5 clutch disk. New throwout bearing. New pilot bearing. New clutch fork boot. Reconditioned shift rods and levers. Hardened steel pressure plate bolts. Nice original clutch fork.
New Flow Tech Headers ($138)- Receipt
New MSD Ignition 6420 Capacitive Discharge 6AL Ignition with Rev Limiter ($205)- Receipt
New MSD Ignition 8203 Blaster 2 Hi-Performance Coil ($52)- Receipt
New MSD Ignition 8213 Chrome Universal Coil Bracket ($10)- Receipt
New MSD Pro-Billet Distributor 8361 Chevy SB V8 ($206)- Receipt
New MSD 31353 Spark Plug Wires. Super Conductor Spiral Core 8.5mm (Black) with 90 Degree Boots. ($78)- Receipt
New 4 Row Aluminum Radiator ($260)
New EdelBrock Elite Series Aluminum Valve Covers
New EdelBrock Elite Series Aluminum Round Air Cleaner ($70)- Receipt
New Battery Tray ($22)
New Windshield Jar with Lid ($14)
New Heater Control Assembly ($160)
These are the list of parts that I have for the car
67 Chevelle 4 speed shifter handle ($75)-Receipt
67 Chevelle 4 Speed shifter T handle adapter ($30)- Receipt
Original bucket seats and bench seat- ($300) Swap Meet
Bucket seats has original correct metal back and sides instead of the 68+ models that use plastic.
Original Cowl Vent Grill Panel
Front Metal Valance Panel ($69)
Manual Trans Center console (No Clock)
New front grille assembly (Ausley’s Chevelle store) ($295)- Receipt
(Front Grill, Grill Extensions, Grill Rivets, Head Light Bezels, and hood moldings)
New Rear Panel Kit (Ausley’s Chevelle) ($245)- Receipt
(trunk lip moldings, upper rear panel and lower rear panel moldings, taillight bezels
New Delux Weatherstrip kit (doors, trunk, window, verticals, hood, vent window, channel rubber, etc) (Ausley’s Chevelle Store) ($130)- Receipt
New Malibu Emblem Kit (Ausley’s Chevelle) ($215)- Receipt
(Grill Emblem, Fender Emblems, and quarter panel emblems)
New Rocker Panel Moldings (Ausley’s Chevelle) ($115)- Receipt
New Hood Loovers (Ausley’s Chevelle) ($95)- Receipt
New Door Handle Kit (Ausley’s Chevelle) ($55)- Receipt
New Front and Rear Bumpers ($330)
I also have the original doors that will be included in the auction.
Spare tire, 2 Car manuals, an extra water pump
The door windows and rear glass is not installed. The door windows are on the original doors (which is included in this listing) and the rear glass is wrapped in a protective sleeve with the original chrome trim (SEE PICS).
396 Chevrolet Chevelle Engine
This motor came out of a 69 Chevelle. Motor is in pieces. Comes with the carburetor (rebuilt) and the distributor. I am not a car expert so look at the pictures to see what parts are there. It is my understanding that the motor is complete (pulleys, camshaft, valves, oil pan, Fly wheel, intake manifold, starter, pistons, connecting rods, fan etc.) I am including an engine stand (shown in pic) and a set of brand new Edelbrock Elite Series Aluminum valve covers and air cleaner (air filter not included).
This car is perfect for a restoration shop or for someone who is handy with cars and has the time. Just needs to be finished.
Roughly $10K+ in parts (Receipts) + 396 Motor and various additional parts (set of original doors, original cowl vent panel, pulleys, extra set of original headlight bezels, spare headlight etc.)
16K FIRM!!
SOLD AS IS!!!
I will not assemble any parts.
Buyer is responsible to pick up parts and vehicle. I am willing to accommodate a little by storing certain parts in the vehicle when its time for pick up. It’s up to the buyer.
Local Pickup Only