1969 CHEVROLET C-20 STEP SIDE PICKUP - PROJECT TRUCK

  • Location: Boonville, New York, United States
  • Condition: Used
  • Make: Chevrolet
  • Model: Other Pickups
  • SubModel: C-20
  • Type: Standard Cab Pickup
  • Year: 1969
  • Mileage: 83,790
  • VIN: CS249B840213
  • Color: Blue
  • Engine size: 6 cylinder
  • Number of cylinders: 6
  • Fuel: Gasoline
  • Transmission: Manual
  • Drive type: RWD
  • Drive side: Left-hand drive
  • Vehicle Title: Clear

1969 Chevrolet Other Pickups Description

FOR SALE: 1969 Chevrolet C-20 Pickup Truck, 6 cylinder (CID unknown), 3 speed manual transmission (on the column), with an eight foot wooden deck, step side box.
History: I purchased the truck in Chesapeake Va in 1999 before moving back to New York later that year. The truck has been parked outside (year round) for the last 19 years.
I believe this truck to be worthy of a restoration project. My intent was to do the same, however over the years I have collected too many vehicles, consequently with regret the truck must go. Selling AS IS with no warranties implied. Please view all pictures/photos closely, they are a valuable part of the description.

A $500.00 deposit, via Paypal, is required within 48 hours of the auction end/purchase.
Balance is due within 2 weeks of auction end. Cashiers/Bank checks must be mailed in advance and clear my bank before truck will be released.
Buyer is responsible for local pickup or shipping.
Serious bidders only please. Bidders with the intent to cause interference or disrupt the auction will be reported to EBAY. I WILL DELETE THE BID FROM ANY BIDDER WITH LESS THAN 5 EBAY TRANSACTIONS AND BLOCK THEM FROM FUTURE BIDS UNLESS I HAVE BEEN CONTACTED PRIOR TO BIDDING.
Thanks for looking. :)

On Oct-29-18 at 18:46:18 PDT, seller added the following information:


On Oct-29-18 at 19:00:26 PDT, seller added the following information:

The truck was last driven when it was parked 19 years ago. There has not been any attempt to start the motor since. Surprisingly nothing seems to be set up on the truck, all the wheels turn/rotate, steers and shifts. I will attempt to put a wrench on the motor to see if it turns over and will post the results.

On Oct-30-18 at 17:39:35 PDT, seller added the following information:

The motor is not set up, I was able to turn the crank back and forth easily (between compression strokes) using the fan blade/belt, no wrench was required. The frame is solid, absolutely no rot, just surface rust (I took several pics, however I wasn't able to post them because I'm maxed out at 24). I was able to add a pic of the right (passenger) side radiator support and fender skirt under the battery tray, its pretty badly rusted. The left (drivers) side is ok.
A bit more history: The truck basically sits as I bought it, I only performed limited mechanical work (front brakes, wheel cylinders, bearings) back in 1999, just enough to get it (minimally) road worthy. All the bodywor, bondo and tin work, was done by the previous owner(s), so I have no idea what its covering.