GR Auto Gallery is pleased to present this 1967 Chevrolet Camaro SS for your consideration. This Camaro was repainted in Ferarri red with the black bumble bee stripe. Completed with a small block Chevy 350ci V8 and a 4 speed manual everything about this '67 is done right. Equipped with power front disk brakes, power steering and a working heater. Lots of tasteful aftermarket parts including; weiand stealth intake manifold, holley street avenger carb, headers, magnaflow exhaust, 3:73 gears, derale... dual fans, 4 core radiator, powder coated suspension, deluxe interior black and much more. There is a book of what else has been done to this frame off Camaro restoration including the original owners manual. Exceptionally low miles on this build and in pristine condition, ready for some great shows. Please call or email us today for more information on this vehicle. The first-generation Chevrolet Camaro appeared in Chevrolet dealerships in September 1966 for the 1967 model year on a brand-new rear wheel drive GM F-body platform and was available as a 2-door, 2+2 seat, hardtop (no "B" or center pillar) or convertible, with the choice of either a straight-6 or V8 engine. The first-generation Camaro was built through the 1969 model year. Almost all of 1967-1969 Camaros were built in the two U.S. assembly plants: Norwood, Ohio and Van Nuys, California. There were also five non-U.S. Camaro assembly plants in countries that required local assembly and content. These plants were located in the Philippines, Belgium, Switzerland, Venezuela, and Peru. To see over 80 photos of the car, including under carriage please visit our website br/-