/ /

1967 Early Ford Bronco restored

  • Location: Basco, Illinois, United States
  • Make: Ford
  • Model: Bronco
  • Type: Halfcab
  • Year: 1967
  • Mileage: 900
  • VIN: U15NLA372++
  • Color: Black
  • Engine size: 5.0/302
  • Number of cylinders: 8
  • Fuel: Gasoline
  • Transmission: Manual
  • Drive type: 4WD
  • Interior color: Black
  • Options: 4-Wheel Drive
  • Vehicle Title: Clear

1967 Ford Bronco Description

1967 ford bronco excellent shape no rust anywhere.Rotisserie restored5.0 v83 speed manual transmission900 miles since restoredThis bronco drives great no shaking and goes straight down the road Cruses at 65 mph with easeA year and a half was spent on the restoration of this bronco.Four-wheel disc brakes
Power brakes
Slotted rotors all 4 corners
4 by 4 by 2 power steering
Dakota digital gauge set with tach
New stainless lockouts
TMI XR low back bucket seats
TMI seat mounts with sliders
33x12.50 18 red letter general grabber tires
American outlaw 18 inch wheels
Duff 3 speed shifter
Dana 20 twin stick shifter
Tilt wheel steering column
Marine radio receiver
Marine radio remote dash mounted
Bluetooth
4 speakers
Powered underseat subwoofer
Stainless steel headers
Dual exhaust
Stainless tips
Rough country 9500 lb
Wireless remote winch
Aluminum winch stop
Aftermarket prerunner bumpers front rear
3 inch lift front coil/ rear springs
Polly bushings all areas
Dual fuel tanks both work
High quality fiberglass cowl hood
Hei distributor
Roller 5.0 (302) motor
Very nice half cab well made reproduction
Bed liner inside and underside of bronco
Perfect frame no rust pitting at all
Optima red top battery
Aluminum 3 core radiator
Led headlights
Stainless steel bolts used in many areas
Wheel well flairs with stainless hardware
Stainless tailgate handle and licence plate brackets
Overhead console
Aftermarket windshield wiper motors
Tire tread aluminum heater knobs,shifters and windowshield hold downs
High definition Ford grill letters
1 piece roadster door inserts
Galvanized tailgate
Galvanized grill powder coated black
Stainless hood latch
Center console (customized)
Bronco rubber full coverage floor cover
Dark tint rear glass
Dana 44 front axle
Dana 44 cast iron cover
Frame off restore
Body was mounted on a rotisserie
High volume heater blower motor
Mini alternator
Mini high torque starter
Base/clear paint
Red led underdash lights
Black aluminum gas caps
Adjustable track bar
Adjustable drag link
Heim joint anti wrap axle bars
New led headlights
New rear taillight lens
New chrome headlight trim
New 66/67 turn signal housings
New front prerunner winch bumper
New rear custom bumper
New galvanized grill black powder coated
New radiator support
New 3 core aluminum radiator
New fan shroud
New red polymer body mounts
New front wheel wells both sides
New battery tray
New optima red top battery
New rough country 9500 lb wireless
Remote control and aluminum stop
New round led off road lights
New front fenders
New fender flares with stainless hardware and rubber welting
New ford high definition grill letters
New windshield
New windshield frame
New windshield rubber
New dark tint rear glass
New driver and passinger floor pans
New tilt steering column
New steering shaft and u joints
Rebuilt 4x4x2 steering box
Rebuilt heater box including heater core and new high flow blower
New tire aluminum tread heater controls
New tire tread windshield hold downs
New shifter tire tread knobs
New marine radio with Bluetooth and dash mounted remote
New 4 speakers
New underseat amplified subwoofer
New digital Dakota gauge set with tach
New light switch
New red led underdash lights
New roadster 1 piece door inserts
New TMI bronco seat mounts
New TMI XR low back bucket seats
New customized center console
Rebuilt Duff 3 speed floor shifter
New Dana 20 dual stick shifters
New brake and clutch (bronco) pedal pads
New plastic glove compartment
New glovebox button
New high quality fiberglass cowl hood
New Stainless hood latch
New dual funtion radiator windshield washer fluid container
New rear view mirror
New side mirrors
New halfcab bulkhead
New seatbelts
New well built fiberglass half cab ( bronco design)
Used overhead console
New steering wheel
New rocker panel passenger side (original was dented)
New galvanized tailgate
New rear 3 inch lift rear leaf springs
New Polly leaf spring bushings
New u bolts
New American outlaw 18x9 wheels
New 33x12.50x18 general grabber red letter tires
New drilled and slotted rear rotors
New rear calipers with parking brakes
New rear brake hoses
New complete brake lines
New rear axle bearings and seals
New rear shocks with boots
New heim joint anti axle wrap bars
New rear tank fuel sender
New rear tank hoses
New auxiliary tank hoses
New auxiliary fuel tank sender
New complete fuel lines
New axle rubber snubbers front and rear
New front shocks with boots
New 3" lift front coil springs
New Polly transfer case bushings
New front end Polly bushings
New adjustable track bar
New adjustable drag link
New tierod set
New steering stabilizer with boot
New front brake drilled and slotted rotors
New front calipers
New stainless steel front brake hoses
New power brake booster and bracket
New aluminum master cylinder
New front wheel hubs
New front wheel bearings
New stainless lockouts
New front axle u joints
New front driveshaft u joints
New rear driveshaft u joints
New water pump
New fuel pump
New carburetor
New plug wires
New hei distributor
New stainless steel headers
New dual exhaust
New stainless steel exhaust tips
New power steering pump
New mini alternator
New mini high torque starter
New 50 oz harmonic balancer
New flywheel
New clutch and pressure plate
New valve covers
New air breather
New radiator hoses
New heater hoses
New stainless steel tailgate handle
New stainless steel licence plate holder
Newly rebuilt roller 5.0 (302)
New motor mounts
New gaskets and bearings in transfer case
Rebuilt 3 speed manual transmission
Newly applied bedliner on interior and underside of the bronco
New Dana 44 cast iron cover
New gaskets and seals in front axle
New upper and lower ball joints
New dual windshield wiper motors
New black base clear coat paint
New rubber complete coverage floor mat
Various other new small items
Coated or stainless steel fasteners
Used throughout the bronco
The frame is in excellent shape.The frame was blasted and painted with industrial paint that is uv resistant and very durable. This frame has absolutely no visible pitting at all.
The underside of the body tub was coated in a heavy thick tar undercoating (long ago) and it preserved it quite well.
This was removed.
The body was attached to a rotisserie and the floor pans were both professionally replaced and seam sealed. The drivers door post was replaced because the hinge area was bent. Also the passenger side rocker panel was replaced because of a large dent in it. the whole body underside was cleaned seam sealed and black (liner extreeme with kevelar) was applied.
The inside of the bronco floor and sides were cleaned prepared and (liner extreeme with kevelar) was applied to it as well.
The front and rear axles along with the transfer case and transmission were inspected and new bearings and seals installed.
The 5.0 efi roller motor was disassembled taken to a machine shop.all required machine work was done and was reassembled (rebuilt)
New carburetor,water pump, distributor,wires and 50 oz harmonic balancer was added.
It was installed with new flywheel,clutch throwout bearing, pressure plate high torque mini starter and mini alternator.
The bronco has a new power steering pump attached to a rebuilt 4x4x2 sector. power 4 wheel disc brakes.front and rear 3.50 gear ratio. Dana 20 transfer case and v8 3 speed transmission ( floor shift)
The Interior was fitted with a digital Dakota gauge with tach, custom dash knobs, marine Bluetooth radio,
Custom center and overhead console, twin stick transfer case shifters, underseat amplified subwoofer,tilt steering column,red led underdash lighting,dual wiper motors for a cleaner look, bronco design fiberglass halfcab that is well made (it has a nice finished look) and complete set of new TMI XR black with red stitching low back seats with mounts and slider's these are very very nice seats.
The exterior: 33x12.50 x18 general grabber radial red letter tires, American outlaw 18x9 wheels 1 piece roadster door inserts (bronco design) cowl hood fiberglass from bronco hut again a well built quality hood, fender flairs with stainless hardware, prerunner winch bumper with a rough country 9500 lb wireless remote winch, matching rear bumper and body was painted in black b/c ( base&clear) paint.Thanks for looking